Modeling with Creo Parametric 2.0

Modeling with Creo Parametric 2.0 synergistically integrates the design process with the specific commands and procedures of Creo Parametric 2.0 through a unique presentation scheme. Users are first provided with the information about the design (part or assembly), and its design intent. Then, they see an overview of steps involved in modeling the part/assembly. This is accompanied by detailed instructions showing goals, steps and commands in a four-column presentation. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts.

Table of Contents

1. Introduction
2. Bearing
3. Bearings
4. Bushing
5. Retaining Ring
6. Nuts and Bolts
7. Shaft
8. Shaft Drawing
9. Radial Plate Cam
10. Housing
11. Cam Assembly
12. Cam Follower Assembly
13. Washington Monument and Wing
14. Gateway Arch
15. Springs
16. Spur and Helical Gears
17. Axial Cam
18. Grooved Cam
19. Bolt Heads
20. Electrical Fuse Assembly